No. LED Muster Description
20
Q
maximum hold mode:
1
Provided
Q
= +U
1
value is stored.
If Q
1
mitted at the analogue output. A minimum
hold can be set by inverting the analogue
characteristic curve (analogue 100% point
< analogue
0 % point).
21
Q
difference hold mode:
1
Provided Q
between the measured values is saved.
When Q
transmitted at the analogue output.
22
Activate factory settings:
When the S button is pressed, the factory
setting is activated.
23
Locking keys:
If function is activated locking becomes
active once the setting mode has been
quit. Cancel locking with RESET or the
unlocking function (see "Unlocking keys")
24
Meas. value hold mode:
If no object is in the measuring range
(good target = off), the last meas. value is
held at the analogue output.
25
Differential measurement mode master:
Activate/deactivate
Description see differential measurement
mode (page 38).
26
Differential measurement mode slave:
Activate/deactivate
Description see differential measurement
mode (page 38).
Reset
When switching on the sensor (power on), keep the S button pressed (approx. 10 seconds) until the LED lights stop
flashing and are permanently on. The BA power supply indicator is green. When the S button is released, a Reset is
carried out which returns the device to delivery status where factory settings are active.
(See table of functions page 3234).
Unlocking keys
When switching on the sensor (power on), keep the T button pressed (approx. 10 seconds) until the LED lights stop
flashing and are permanently on. The ZA status indicator is red. When the T button is released, the setting mode is
unlocked.
34
, the max. recorded measured
B
= U
, the determined value is trans
B
= +U
, the difference
1
B
= U
, the determined value is
1
B
"ZA" status indicator
On = Maximum hold active
Off = Maximum hold not active
On = Difference hold active
Off = Difference hold not active
ZA lights up as long as the S button
is pressed
On = Locking is active
Off = Locking is not active
On = Meas. value hold is active
Off = Meas. value hold is
not active
On = Differential measurement
mode master is active
Off = Differential measurement
mode master is not active
On = Differential measurement
mode slave is active
Off = Differential measurement
mode slave is not active
3RG72563NQ00PF Distance sensor 06813787 / 453489 Stand: 03/2011
Mounting and
operating instructions
Factory setting
Not active
Not active
Not active
Not active
Not active
Not active
Not active