Removing The Blade Covering Plate; Removing The Blade Scraper; Removing The Last Slice Device Plate; Cleaning The Machine - Hofmann Profiline A 3307 P Instructions D'utilisation

taking care not to let it jam.
Important
The carriage can be dropped down only, if the
adjusting knob for the cutting thickness is tur-
ned clockwise to stop.

5.3. Removing the blade covering plate

• Put on safety gloves.
• Unscrew the knob on motor body. Push the blade
cover plate gently against the blade.
• Take off the blade cover plate by holding it in
both hands by the top and bottom and lifting it
away from the blade.

5.4. Removing the blade scraper

Pull up the deflector. (Swallow-tail guide)

5.5. Removing the last slice device plate

Important!
For safety reasons the last slice device plate
may removed only when the carriage has been
removed.
• Lift up the food holder
• Loosen the knob on the last slice clamp plate.
• Pull off the last slice clamp plate

5.6. Cleaning the machine

Clean removable and non-removable parts accor-
ding to the cleaning schedule.
Warning !
Danger of injury ! Wear protective gloves !
Important !
Do not place the parts on top of each other.
Risk of damage.
Use a linen cloth to carefully clean the blade on the
inside and outside. Clean all surfaces of the machi-
ne.

5.7. Blade and blade ring cleaning

WARNING!
The blade is sharp!
Only clean it when the carriage is tilted out and
the limit stop is closed.
• Push a dampened cleaning cloth between blade
and blade protection ring from the front.
• Using both hands, pull the cleaning cloth against
the blade guard ring once or twice.
• Press a damp cloth against the blade surface and
wipe off the blade slowly from the centre to the
edges.
• Clean the rear side of the blade in the same way.
• Rub the blade dry with a clean cloth in a similar
fashion.

5.8. Assembly

• Put on the blade cover plate and screw the knob
on the motor body into the blade cover plate.
• Put in the last slice clamp plate into the last slice
clamp.
• Put carriage into the carriage base.
• Push down the carriage firmly with both hands.
• Tighten the knob on the base of the carriage.
• Lower the blade scraper into the swallow-tail gui-
de and carefully press it down.
6.

Maintenance

6.1. Lubrication

Warning !
Rotating blade ! May sever fingers.
Switch off the machine prior to servicing.
Important !
EN
21