Setup And Connection; Attaching The Stands To The Printer; Connecting The Printer To A Computer - Sony UP-DP10 Mode D'emploi

Setup and Connection

Attaching the Stands to the
Printer
The stands can be attached by screws. The
mounting of the stands depends on whether the
printer is going to be used in the vertical position
or the horizontal position. (Refer to the
illustration.)
<For vertical orientation>
<For horizontal orientation>
Connecting the Printer to a
Computer
Notes
• Before connecting the printer to a computer, be
certain to first turn off the power for the printer,
the computer, the monitor, etc.
• Read the operating manual for the personal
computer carefully.
• When connecting to a printer port, we
recommend using a shielded printer cable not
more than 2m long and with a double-ended
ferrite core.
• Make sure that you insert the cable connectors
all of the way when making the connections.
• The driver provided with this printer does not
support usage through a network.
• Proper operation can not be assured when USB
connection is made through a hub.
• The printer cannot be connected using both a
USB cable and a parallel cable. Connect it using
one type of cable or the other.
When connecting to a USB port
To USB port (B connector end)
To USB port
(A connector
end)
Note
Only the USB port can be used for connection to
a Macintosh computer. (This printer cannot be
used with a Macintosh that does not have a USB
port as a standard feature.)
USB cable
(purchased separately)
Windows 98 computer
Macintosh
7