Snowflake SKF20 Manuel D'exploitation page 28

OPERATING MANUAL
USE OF STANDARD PROGRAMS
The standard programs are the running cycles recommended by the manufacturer, i.e. programs in which the
parameters have already been set.
SOFT QUICK COOLING CYCLE WITH CORE TEMPERATURE PROBE
HARD QUICK COOLING CYCLE WITH CORE TEMPERATURE PROBE
QUICK FREEZING CYCLE WITH CORE TEMPERATURE PROBE
Press the quick cooling cycle with core temperature probe key to select a SOFT quick
cooling cycle with core temperature probe.
The display shows SOFT for 3 seconds.
The core temperature probe icon and the quick cooling icon fl ash.
The display shows the minimum target temperature of the cabinet interior probe during
the quick cooling.
Press the Standby key to start the cycle.
Press the SOFT quick cooling with core temperature probe key to select a SOFT quick
cooling cycle with core temperature probe.
The display shows SOFT for 3 seconds.
Press the quick cooling with core temperature probe key to select a HARD quick cooling
cycle with core temperature probe.
The display shows HARD.
The core temperature probe icon and the quick cooling icon fl ash.
The display shows the minimum target temperature of the cabinet interior probe during
the quick cooling.
Press the Standby key to start the cycle.
Press the quick freezing with core temperature probe key to select a quick freezing
cycle with core temperature probe.
Core temperature probe icon and quick freezing icon fl ash.
The display shows the temperature setpoint for the cabinet interior temperature probe
during the quick freezing.
Press the Standby key to start the cycle.
28