Snowflake SKF20 Manuel D'exploitation page 21

CONTROL PANEL
DESCRIPTION OF CONTROLS
TIME-CONTROLLED QUICK COOLING KEY
With the control in Standby mode:
Press the key once to select a time-controlled SOFT quick cooling cycle.
•
Press the key a second time to select a time-controlled HARD quick cooling cycle.
•
DEFROST KEY
With the control in Standby mode:
• Press the key once to start a defrost cycle if the evaporator temperature is cold
enough.
STANDBY KEY
With the control in OFF mode:
• Press the key once to set the control to Standby.
With the control in Standby mode and the cycle selected:
• Press the key once to start the selected cycle.
With the control in cycle running mode:
• Press the key once to interrupt the cycle.
If this key is pressed for three seconds, the appliance will be switched to
NOTE:
Standby irrespective of present control mode.
TIME-CONTROLLED QUICK FREEZING KEY
With the control in Standby mode:
Press the key once to select a time-controlled quick freezing cycle.
•
QUICK COOLING WITH CORE TEMPERATURE PROBE KEY
With the control in Standby mode:
Press the key once to select a SOFT quick cooling cycle with core temperature probe.
•
Press the key again to select a HARD quick cooling cycle with core temperature
•
probe.
UP AND DOWN KEYS
Use these keys to increase or decrease a value.
QUICK FREEZING KEY WITH TEMPERATURE PROBE KEY
With the control in Standby mode:
• Press the key once to select quick freezing cycle with core temperature probe.
21
ENGLISH
SECTION 2