Güde P 2300 A Mode D'emploi Original page 12

Parts Description
16
15
11
13
12
9
8
6
Technical Data
Supply voltage:
Motor input power:
Maximum speed:
Protection:
Noise level:
Weight:
Product No.:
General Safety Precautions
Read the instruction manual carefully before the first use of the machine. If any doubt regarding the connection and operation of the
machine arises, seek the manufacturer's assistance (servicing department)
Protect the machine from moisture, rain and dust.
FOR US TO SECURE THE HIGHEST DEGREE OF SAFETY, CONFORM TO THE FOLLOWING INSTRUCTIONS:
- Use the machine only for the scope of work it has been designed for !
- When using the saw-chain grinder outdoor, you should always use a weather resistant extension cable to connect it of a
minimum diameter of 1.5 mm
- The noise level in the working area is above 85 dB (A). Therefore, wear ear protection – hearing loss is imminent!
- To protect your health at a grinding job, always use a dust protection mask and protective goggles!
- Always unplug the machine before any work on the machine (cleaning, grinding disk replacement etc.)
- Take care to have the saw-chain to be ground secured as appropriate for it not to slip out.
- It is your own interest to keep your machine clean at any time and after you finish a grinding job, check the machine for damage.
- Always keep your saw-chain grinding machine clean. .
- Do not use any caustic to clean the plastic parts.
- Do not use the machine and do not work on it in proximity of inflammable liquids and vapours thereof. .
- Unplug the machine any time you replace a part or clean the machine.
- Protect the power cable from any damage the cable may be damaged by oil or acid.
- Important notice! Observe any national safety regulations regarding installation, operation and maintenance .
- Upon having completed the job, unplug the saw-chain grinding machine from the mains.
- Protect your yes and colleagues from jumping particle and chips.
- Working gloves will protect your fingers and skin from cutting injuries.
- Always carry the power cable to the machine from behind.
- Store the machine in a place inaccessible to children.
- Always hold the machine with both the hands when working and mind safe footing and posture.
1
2
14
7
P 2300 A
230 Volt/50 Hz
230 W (P1)
3000 rpm
IP 20
L 85 dB (A)
WA
ca. 4,8 kg
94135
2
with the splash-proof plug and socket.
1.
2.
3.
4.
5.
6.
7.
8.
9.
3 10. mean distance set screw
11. guide flap valve
12. screw clamp
13. guide position set screw
4 14. setting screw
15. grinding disk
16. grinding disk protective enclosure
5
10
12
handpiece
grinding disk lateral guard
depth of grind set screw
cutting edge angle set-up wheel
base
screw clamp cradle
cutting angle setting wheel
scale
clamping lever