Güde P 2300 A Mode D'emploi Original page 13

CAUTION!
Abide by the essential safety measures of protection from electric shock, accident and fire prevention. Read all these instructions
before you get down to the use of the electric machine and follow them. Keep the safety instructions at a safe place for future
reference .
Safe Work
- Keep your workplace tidy.
A messy work place may cause an accident.
- Always make allowances for the environmental effects. Do not expose the electric tools to rain. Do not use them in moist or wet
areas. Take care of sufficient lighting. Do not use them in proximity of flammable liquids or gases.
- Get protected from electrical shock. Avoid any bodily contact with grounded objects (such as pipes, radiators, stoves and
refrigerators).
- Prevent the children from access.
Do not let other person to touch the machine or the cable. Prevent any unauthorised persons from access to the working area.
- Store the machine at a safe place. When off the use, the machine should be kept at a dry, elevated locked place out of the reach
of children.
- Do not overload the machine.
Work better and in a safer manner within the scope of capacity as given.
- Use the correct machine. Do not use a machine of lower capacity for heavy jobs. Do not use the machine for any purpose it has
not been intended for. Only use the machine for the purposes described in the instruction manual!
- Wear proper working clothing!
Do not wear any wide garments and jewellery that might be caught by the moving machine parts. For working outdoors, rubber
gloves and non-skid shoes are recommended. If your hair id long, wear a hairnet. Use protective goggles.
- Wear a breathing mask when engaged in a dust-producing job.
- Do not use the cable for any purpose it has not been designated for.
Do not use the cable for carrying or hanging of the machine. Do not use the cable to pull out the plug from the socket. Protect the
cable from excessive temperatures, oil, and sharp edges.
- Avoid any abnormal posture. Mind safe footing and keep balance at any time
- Take due care of your machine.
Abide by the maintenance and grinding disk replacement regulations.
Check the machine cable regularly and when it is found to be damaged, have it replaced by a skilled electrician. Check the
extension cables regularly and replace them if damaged.
Keep the handle dry, free of any dir, oil and grease.
- Unplug the machine, if it is out of use, prior to the maintenance and tools replacement, e.g. grinding disk.
- Remove any spanners from the machine.
Before switching on, check to see that any wrenches and adjustment tools were removed.
- Avoid an unintended switching.
Use only permitted and properly marked extension cables for working outdoors.
- Be attentive. Mind what you are doing. Get down to a job only when feeling good. Never use the machine when distracted.
- Check the machine for possible damages.
- Before using the machine, you should check any protection devices and any parts showing slight damage to see that the function
intended is perfect. Check to see that the moving parts move freely, do not drag and are not damaged. Any parts should be
installed properly to comply with the conditions of the machine safe operation. Damage protection devices and parts should be
repaired in a recognised professional workshop and replace unless the instructions for use specify otherwise. Damaged
switched should be replaced by the customer service workshop. Do not use a machine with a defective ON/OFF switch.
CAUTION!
Always connect the machine via fault current circuit breaker (FI). This machine is in compliance with any respective safety
provisions. Any repairs shall be done by professionally qualified persons and only genuine spare parts should be used. The
provision not being observed, the operator is in a risk of injury.
13