Before Use; Working Procedures; Dust Extraction; Operation - Parkside PMDS 100 B1 Traduction Des Instructions D'origine

Residual risks!
Even if you operate this power tool properly, there
will still be residual risks. The following risks can
occur in the context of the design and construction
of this power tool:
a) Lung damage, if no suitable breathing protection
is worn.
b) Hearing damage, if no suitable hearing protec-
tion is worn.
c) Damage to health caused by vibrations if the
appliance is used for extended periods or is not
properly used and maintained.
WARNING!
► The power tool creates an electromagnetic
field during operation. This field can, in
certain circumstances, impair active or pas-
sive medical implants. To reduce the risk of
fatal injuries, we recommend that people with
medical implants consult their doctor and the
manufacturer of the medical implant before
operating this machine.

Before use

Working procedures

A light grinding pressure is sufficient:
work using a light grinding pressure – in particular,
a constant and correct speed delivers a high grind-
ing performance.
Grinding:
bear in mind that the workpiece heats up during
grinding. Therefore, cool the workpiece in a water
bath.
│ GB │ IE
■ 16
CAUTION!
This appliance is not designed for continuous

operation.

► If the appliance overheats, switch it off and
allow it to cool down.

Dust extraction

WARNING!
► Risk of fire! This appliance has a grinding
dust draw . Risk of fire! In unfavourable
conditions, e.g. when sparks are flying while
sanding metal or metal residues in wood,
wood dust in the grinding dust draw
spontaneously ignite. This is a particular risk
if the wood dust is mixed with paint residues
or other chemicals and the workpiece has
become hot after being worked for a long
time. Therefore, avoid overheating of the ma-
terial being sanded as well as the appliance.
Always empty the grinding dust draw
before taking work breaks.
Wear a dust mask!
Operation
Switching on and off
NOTE
► Before first use, allow the grinding disc to
run without a load at top speed for about 5
minutes. Keep out of the danger area.
♦ Undo the knurled screw
and set the desired grinding angle (see fig. A).
♦ Re-tighten the knurled screw
WARNING – RISK OF INJURY!
► There must be a gap between the grinding
disc , and the workpiece rest
4a 4b
♦ Undo the knurled screw
cover and adjust this so that it provides the
greatest possible protection (see fig. A).
♦ Re-tighten the knurled screw
ATTENTION! Repeat the settings on the op-
posite side.
can
on the workpiece rest
afterwards.
.
on the protective
afterwards.
PMDS 100 B1