Enrolling Wireless Accessories; Rectifying Faults - Pentatech MA80 Mode D'emploi

Preparing for first use / Rectifying faults

Enrolling wireless accessories

The following accessories can be enrolled to the MA80:
- Wireless remote control MA80R(v.2) – max. 2 pcs.
(ie. 1 additional control) / EW01R
And a total of 6 pcs. of the following:
- Wireless door/window contact MA80KM(v.2)
- Wireless movement detector MA80P(v.2)
Each accessory has a unique factory-set code. This code
must be enrolled into the MA80 as follows:
Insert the battery into the accessory.
The MA80 must be disarmed, "ARM" is not visible
on the display.
Open the lid of the connection compartment
described in the section "optional connections".
Press the LEARN button (see Fig N) with a pencil until
you hear a beep. The MA80 is now in the enrolment
mode for 20 seconds.
Move in front of the MA80P, separate the magnet
from the reed contact of the MA80KM, or press a
button on the MA80R. A coded signal will be
transmitted.
The successful enrolment of the code will be con-
firmed with two long beeps.
If no component has been enrolled within 20 seconds
the enrolment mode closes automatically. This is
confirmed with 4 beeps.
Repeat the above procedure for each component.
If an enrolled component is enrolled again the first
enrollment will be automatically overwritten.
46 GB

Rectifying faults

Fault Cause
Motion de- Pets, air move-
tector de- ments, direct
tects motion light, etc.
without ap-
parent rea-
son.
as The range of Ambient tem-
A
the motion perature is too
detector is high (20 °C is
not adequate. optimal).
Device is mount-
ed too low or
too high.
The There is no
LED flashes backup battery
regularly. connected or
the connected
backup battery
is too weak.
The called The telephone
number number was in-
does not re- correctly or not
ceive a call entered.
on alarm.
Fault
Remedy
Change the position
of the motion detector.
Use a masking
sticker to restrict a
particular part of
the detection angle /
range. The device
does not re-
Change the position act to the
of the motion detec- password.
tor.
Change the mount-
ing height or the in-
clination of the mo-
tion detector.
Connect a new
backup battery.
your set-
Enter the telephone tings were
number again. not stored.
There are
other faults
Cause Remedy
Dialling function Set the dialling
is switched off function on.
( appears on ( does not appear
the LC display. on the LC display.
The telephone Check the tele-
line is faulty. phone line with an
analogue telephone.
you have not yet Press the OK key
given a com- to arm/disarm the
mand after device.
password entry.
Press the PROG key
to enter settings
r
mode.
The password Enter the correct
entered is password.
wrong. If you have forgotten
the password, set
the device back to
the factory settings
as described in the
section "Changing
the password".
The settings Press the OK key
were not con- to confirm the
firmed. settings.
Carry out a reset
(see section "Mak-
ing the settings"
item "Reset").
y
y