Preliminary Warnings - Ferplast CAPRI LED 50 Manuel D'utilisation

CAPRI LED aquariums
GB

PRELIMINARY WARNINGS

IT
• Check that all parts are undamaged (lights,
heater, glass and plastic parts, etc.). Ferplast
uses strong, secure packaging and checks each
FR
aquarium individually, but we recommend
you also check that no accidental damage
has occurred during transport, storage or sale
D
which could affect its watertight seal and safe
use.
• Ensure that the voltage shown on the all
NL
electrical components corresponds to that of
your home electrical power supply.
• The aquarium is intended only for indoor use.
• Before switching on make sure your home
ES
is protected by an automatic safety breaker
switch (or individual breaker plug) with an
operating current of no more than 30 mA.
PT
• Do not connect the aquarium to the power
supply before correctly completing all the
installation procedures, including filling with
SK
water.
• Always disconnect all appliances from the
electric power supply before carrying out any
CS
maintenance.
• Remember that the protection of the lights
from water and dust is guaranteed only when
HU
the fluorescent tubes are correctly inserted and
the ring nuts perfectly tightened.
• The light must never be submerged.
SV
• The power cable has Z-type wiring, so if
damaged it must be replaced by a qualified
electrician.
DA
• All special maintenance work must be
carried out by a qualified electrician. 'Special
maintenance' means any kind of work
PL
not included in the paragraph 'CAPRI LED
AQUARIUM MAINTENANCE' and 'BLUWAVE
FILTER MAINTENANCE' . 'Qualified electrician'
RU
means any qualified member of the register of
installer.
• Never remove the heater (if present) from
6
the water when it is connected to the electric
power supply. Before removing the heater,
disconnect it and leave it to cool inside its
housing for at least 5 minutes.
• Check that the filter intake grilles are not
blocked.
• Always ensure that the water level stays above
the minimum level and below the maximum;
both are marked on the front of the BLUWAVE
filter. Remember that the water level should
always be between the MIN and MAX levels,
both shown on the front of the BLUWAVE filter
and always at 1.5 cm distance from the lamp.
• Do not damage the silicone cord with scissors,
pliers, brushes or scrapers.
• Do not use detergents, solvents or chemical
products (descaler,
products, etc.) to clean the glass, as they could
damage the silicone, causing it to become
detached (possibly some time later).
• Do not use adhesives or adhesive tape near the
silicone when applying backgrounds.
• Moreover, you should always use a spirit level
to make sure that the aquarium is placed on a
perfectly flat surface in both directions (length
and depth), so as not to break the glass or
damage the silicone.
• This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be
made by children without supervision.
• Keep the appliance and its cord out of reach of
children less than 8 years.
ammonium-based