GE Monogram ZEK938 Manuel Du Propriétaire page 11

Clock
To set
the clock
Power
failure
Timer
The clock must be set for the automatic oven
timing functions to work properly.
The time of day clock cannot be changed during
Delay Start. (It can be changed during a regular
bake or broil operation.)
1 Press the CLOCK pad.
2 Press the number pads the same way you
number pads 1, 2, 3 and 4 in that order.
If number pads are not pressed within one
minute after you press the CLOCK pad, the
display reverts to the original setting. If this
happens, press the CLOCK pad and re-enter
the time of day.
3 Press the START pad. This enters the time and
starts the clock.
To check the time of day when the display is
showing other information, simply press the
CLOCK pad. The time of day shows until another
pad is pressed.
If a flashing time of day is in the display,
you have experienced a power failure.
Reset the clock.
NOTE: The timer is independent of all the other
functions and it does not control the oven. The
CLEAR/OFF pad does not affect the timer.
You may program the timer to time cooking
or other household activities for up to 9 hours
and 59 minutes.
The timer counts down in minutes, 1 minute
at a time, until the last 60 seconds are reached.
Then the control will beep one time. The seconds
will not be displayed until the last minute is
reached.
Oven Control, Clock & Timer
Wall Oven
To reset the clock, press the CLOCK pad.
Enter the correct time of day by pressing
the appropriate number pads. Press the
START pad.
will beep 3 times followed by one beep every
6 seconds until the TIMER ON/OFF pad is
pressed.
The 6-second tone can be canceled by following
the steps in the Special Features of Your Control
under Tones at the End of a Timed Cycle.
11