Husqvarna T535i XP Manuel D'utilisation page 19

To do a check of the keypad
1. Start the product. See
13
2. Press the start/stop button again.
3. Make sure that the product stops when you press
and hold the button. The green LED will go off.
To do a check of the battery and the
battery compartment
1. Clean the battery and the battery compartment with
a soft brush.
2. Make sure that the cooling slots and battery
connectors are clean.
3. Make sure that the battery is not damaged and there
are no other defects, such as cracks.
959 - 001 - 16.11.2018
To start the product on page
To do a check of the battery charger
1. Make sure that the battery charger and the power
supply cord is not damaged. Look for cracks and
other defects.
To clean the cooling system
The product has a cooling system that keeps the
temperature of the product as low as possible.
The cooling system includes an air intake on the left side
of the product and a fan on the motor.
1. Clean the cooling system with a brush weekly or
more frequently if necessary.
2. Make sure that the cooling system is not dirty or
blocked.
CAUTION: A dirty or blocked cooling
system can cause the product to
become too hot. This causes damage to
the piston and cylinder.
To sharpen the saw chain
Information about the guide bar and saw
chain
Replace a worn or damaged guide bar or saw chain with
the guide bar and saw chain combinations
recommended by Husqvarna. This is important in order
to keep the safety functions of the cutting equipment.
Accessories on page 27 , for a list of replacement
See
bar and chain combinations that we recommend.
19