Before Initial Use; Removing / Charging / Inserting The Battery Pack; Checking The Battery Charge; Start-Up - Parkside PAHS 12 A1 Instructions D'utilisation Et Consignes De Sécurité

General safety advice for electrical power tools / Before Initial Use / Start-up
Children should be supervised to ensure that
they do not play with the device.
Single use, non-rechargeable batteries must
never be recharged.

Before Initial Use

Removing / charging /
inserting the battery pack
Note: The battery packed is delivered partly charged.
Charge the battery pack with the included charger,
ideally for a minimum of 3 hours. This will ensure
the battery delivers full power. Li-Ion batteries can
be charged at any time without reducing the life. In-
terrupting the charging process does not damage
the rechargeable battery.
1. To remove the rechargeable battery pack
press the release buttons
tery pack out of the unit.
1
2. Insert the battery pack
3. Insert the mains plug into the mains socket. The
charge indicator
11
4. The green charge indicator
is complete and the battery pack
for use.
5. Slide the battery pack

Checking the battery charge

The battery LED indicates the status or remain-
10
ing charge as:
RED/ YELLOW/ GREEN = maximum charge/ power
RED/ YELLOW = medium charge/ power
RED = low charge – recharge battery

Start-up

Note! Always switch the hand grinder on before
applying it to the material, then apply.
Switching the unit on:
Press the ON / OFF switch
40 GB
1
and slide the bat-
2
into the charger
1 13
will light up red.
shows charging
12
is ready
1
into the unit.
1
.
9
Switching the unit off:
Press the ON / OFF switch

Vacuum dust extraction

Q
the danger of fire when working with electrical
devices that have a dust box or can be connected
to a vacuum cleaner. Under certain conditions the
wood dust in the dust extraction bag (or in the
vacuum's dust bag) may ignite, e.g. as a result of
flying sparks generated when abrading metals or
metal objects left in wood. This can happen par-
ticularly if the wood dust is mixed with paint resi-
due or other chemicals and the abraded particles
are hot from prolonged abrasion. Therefore you
must empty the device's dust collection box and the
vacuum cleaner's dust bag before taking a break
or stopping work and always avoid overheating of
the abraded particles and the device.
.
Wear a dust mask!
Dust box for internal
Q 
vacuum extraction
Mounting:
Slide the dust box for self-generated dust ext-
raction up to the stop on the hand sander.
5b
Removal:
 
P ress the release button
box for internal vacuum extraction
withdraw it towards the rear of the device.
Note: Empty the dust collector in good time in or-
der to ensure the optimum removal of
suction.
To do so, remove the dust box
vice as described above. Open the dust box
by pulling on the tab
Now tap both parts to thoroughly clean them.
.
9
DANGER OF FIRE! There is
of the dust extraction
6
and
5b
dust by
5b
from the de-
5b
and remove the cover.
5a