■
Avoid sanding lead paint or other harmful
materials.
■
Materials containing asbestos must not be
processed. Asbestos is a known carcinogen.
■
Avoid contact with the sanding sheet while the
appliance is running.
■
Do not use the appliance without a sanding
sheet fitted.
■
Never use the appliance for other purposes and
only use original parts/accessories. Using
attachments or accessory tools other than those
recommended in the operating instructions can
lead to a risk of injury.
■
Always allow the appliance to come to a
complete standstill before putting it down.
■
The appliance must always be kept clean,
dry and free from oil or grease.
Original accessories/auxiliary
equipment
■
Use only the accessories and additional
equipment that are specified in the operating
instructions and are compatible with the
appliance.
WARNING!
■
Do not use any accessories that are not
recommended by PARKSIDE. This can lead to
an electric shock and fire.
PAEXS 20-Li A1
Before use
Charging the battery pack
(see fig. A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack
the battery pack to the high-speed charger
NOTE
►
Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
♦
Plug the battery pack
charger
(see fig. A).
♦
Insert the power plug into the socket. The red
control LED
lights up.
♦
The green LED
indicates that the charging
process is complete and the battery pack
ready.
ATTENTION!
♦
If the red control LED
that the battery pack
cannot be charged.
♦
If the red and green control LEDs
flash, this means that the battery pack
defective.
♦
Disconnect the power plug from the mains
power socket. Remove the battery pack
the high-speed charger
♦
Never recharge a battery pack
diately after rapid charging. There is a risk that
the battery pack
reduce the lifespan of the again.
♦
Switch the high-speed charger
15 minutes between successive charging
processes. Also disconnect the power plug from
the mains power socket.
from or connect
into the high-speed
flashes, this means
has overheated and
both
.
again imme-
will overheat, which will
off for at least
GB │ IE
│
7
.
is
is
from
■