Handling; Transport - Kollmorgen AKM 2G Manuel D'installation

AKM2G Instructions | 1 English

1.2.4 Handling

1.2.4.1 Transport

Climate category 2K3 according to IEC 60721-3-2, EN61800-2
l
Temperature: -25...+70°C, max. 20K/hr change
l
Humidity: rel. humidity 5% - 95% , no condensation
l
Only by qualified personnel in the manufacturer's original recyclable packaging
l
Avoid shocks, especially to the shaft end
l
If the packaging is damaged, check the motor for visible damage. Inform the carrier and, if
l
appropriate, the manufacturer.
Transport of motors with a weight of more than 20kg
Lifting eyes must be used to safely transport AKM2G7 motors (> 20kg). Observe any trans-
port instructions included in the packaging of the motor.
We recommend the transport tool ZPZM 120/292 for moving the motors.
Suspension Unit ZPMZ 120/292 consists of a beam, suspended to the crane hook and two
double-run chain suspenders.
DANGER
Suspended load. Risk of death if load falls. Never step under the load,
while the motor is raised.
The fastening screws of the lifting eyes must be fully screwed in.
l
The lifting eyes must be positioned on the supporting surface in an even and flat manner.
l
Prior to use, check the lifting eyes for secure fitting and any obvious damages (corrosion,
l
deformation).
Lifting eyes with deformations must not continue to be used.
l
8 Kollmorgen | kdn.kollmorgen.com | August 2018