Side Mounting - Agilent Technologies TwisTorr 84 FS Notice De Mode D'emploi

17 Technical Information
TwisTorr 84 FS On Board Controller Installation

Side Mounting

NOTE The L-shaped bracket (P/N X3500-68006) is available as an option.
See the following figure.
1
2
3
4
5
6
7
318/336
Screw the 4 fixing studs (provided with the accessories bag) in
the holes on the L-shaped bracket;
Place the controller on the studs aligning the 4 rubber holes on
the controller top;
Press the controller towards the bracket;
Turn the pump upside-down;
Place the bracket on the pump bottom;
Screw a little bit the three screws M4 in the holes on the pump
bottom;
Rotate the bracket until the controller is on the chosen position;
TwisTorr 84 FS User Manual / 87-901-043-01(B)