Gaggia Milano BRERA Sup 037RG Mode D'emploi page 23

4 Make sure the selector switch is in the
" " position.
5 Press and hold the 2 brew buttons at the
same time for 3 seconds: the descaling
cycle is started.
ing immediately after start-up, turn
the selector switch right to the "
position. When the "
"
turn the selector switch back to the
" " central position.
6 The "
machine has entered the descaling
automatic programme; when the
" " light is steady, the 1
removal phase is on.
7 When the "
blinking, turn the selector switch
clockwise to the "
case, the steam/hot water wand starts
dispensing the descaling solution at
regular intervals.
8 The "
machine has entered the descaling
automatic programme; when the
" " light is steady, the 1
removal phase is on.
4219-465-04361 GAG. MAN. BRERA US EN-ES-PT Rev 00.indd 23
Note: if the " " and "
indicator lights start blink-
", " " and
" indicator lights start blinking,
" light blinks to show the
limescale
st
" and " " lights start
" position; in this
" light blinks to show the
limescale
st
"
"
9 When there is no more descaling solu-
tion left in the water tank, the "
" " and " " lights blink simul-
taneously.
10 Turn the selector switch to the " "
central position.
Empty the container under the steam
wand and the one under the dispensing
spout.
11 The " " light turns on and the water
tank must be removed before entering
the next stage.
12 Remove the water tank, rinse it and
fill it up to the "MAX" level with fresh
drinking water.
13 Place the tank back in the machine. The
two " " lights turn on showing the
machine has entered the rinse phase.
The " " and " " lights are blinking
in the display.
14 Place an empty container under the
steam wand and another one under
the dispensing spout.
Turn the selector clockwise to the "
position.
• 23 •
15/10/2020 12:06:45
" ,
"