Mounting The Magnifying Glass; Placement Of The Base; Use; Using The Product - Powerfix Profi HG09204 Instructions D'utilisation Et Consignes De Sécurité

Mounting the magnifying glass

Insert the ball joint
and tighten the fastening screw
clockwise (Fig. A).
Push the fixing clamp
set the desired height. Tighten the fastening screw
turning it clockwise.
Placement of the base (Figure D)
The soldering iron holder
right or left side on base
cluded) as an option for left or right-handed user.
The soldering iron holder
correct position to rear side of the base
Figure D in order to prevent restriction on use of the preci-
sion engineer's LED magnifying glass
and alligator clips

Use

Using the product

Turn the retaining screws
clockwise direction. Clamp the item to be repaired with
the alligator clips
14 GB/IE/NI
into the corresponding recess
5
on to the mounting rod
7
could be installed on either
13
with screwdriver (not in-
14
should be adjusted the
13
.
18
on the alligator clips
19
in the repair device
18
for the ball joint
6
as shown in
14
, fixing clamp
1
.
15
5
and
10
by
8
11
in a
18