Inserting the batteries (Figure C)
Remove the battery compartment cover
battery compartment
the arrow.
Insert the three batteries supplied
compartment
Note: Ensure the ribbon
the batteries with the correct polarity. This is shown in the
battery compartment
Push the battery compartment cover
direction to the arrow back to its original position in order
to close the battery compartment
Attaching the repair device
Insert the ball joint of the repair device
corresponding recess of the fixing clamp
Fix the repair device
fastening screw
Tightening the retaining screws
for holding the supporting rod
Turn the locking screws
clips
properly.
18
Push the fixing clamp
the desired height and tighten the fastening screw
clockwise.
by pulling in the direction of
4
.
4
24
.
4
in place by tightening the
15
clockwise.
16
tightly for fixing the Alligator
23
onto the mounting rod
11
from the
3
into the battery
21
is under the batteries and
in the opposite
3
.
4
into the
15
11
in clockwise direction
17
properly.
22
.
, set
10
12
GB/IE/NI
13