Settings; Tool Holder, Attachments - Festool C 12 Li Guide D'utilisation

using two screws (e.g. round head or flat
head screw with shank diameter of 5 mm).
Insert the two screws into the wall at a
distance of 96 mm from one another and
leave the screw heads protruding approx.
4 mm.
Consider the pictures on the fold-out page.
Changing the direction of rotation
The right/left switch
tion of rotation.
• Move switch from right to left = clockwise
rotation
• Move switch from left to right = anticlock-
wise rotation
Changing gear
Always switch off the machine before
changing gear!
You can change gear using the gear switch
[1-4].
• Switch forwards (Number 1 visible) = first
gear
• Switch backwards (Number 2 visible) =
second gear
WARNING
Risk of injury
Make sure that the machine is switched off
and the battery pack has been removed
before changing the tool holding fixure,
attachments and tools.
[1-8] changes the direc-

Tool holder, attachments

4 mm/
0.16''

Settings

Adjust the switch
faces the screw symbol [1-6]. The torque
can be adjusted in this position.
The switch-over function only works if the
machine is switched off.
Adjust the torque accordingly at the
torque wheel [1-1]:
Position 1 = low torque
Position 25 = high torque
The machine switches off when the preset
torque is reached and an acoustic signal
sounds. The machine only continues running
when the on/off switch
then pressed again.
Adjust the switch
faces the drilling symbol [1-5]. Maximum
torque is set in this position.
Tool chuck CENTROTEC WH-CE
The tool chuck CENTROTEC WH-CE allows
you to change tools with a CENTROTEC
shank in a matter of seconds.
Always use a CENTROTEC tool chuck to
clamp CENTROTEC tools.
Risk of cutting injuries when changing
the tool!
Wear protectiv gloves!
96 mm/
3.78 ''
Fastening
[1-7] so that its marking
[1-9] is released and
Drilling
[1-7] so that its marking
CAUTION
11