Settings; Tool Holder, Attachments - Festool PDC 18/4 Notice D'utilisation D'origine

Masquer les pouces Voir aussi pour PDC 18/4:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
English
1x ... LED, working area illumination
2x ... capacity indicator, indicates the charg­
ing state of the battery pack (not with NiCd
and NiMH battery packs)
LED green – lit continuous­
ly: charged > 60 %
LED green – flashing slow­
ly: charged 30 % – 60 %
LED green – flashing quick­
ly: charged 0 % – 30 %
LED yellow – lit continu­
ously: battery is empty
LED red – lit continuously:
battery temperature is out­
side the permitted range.
LED red – flashing: indi­
cates a general fault, e.g.
incomplete contact, short
circuit, battery pack faulty,
etc.
6.3
Capacity indicator
The capacity display [1-14] indicates the charge
of the battery pack for approx. 2 seconds after
the button [1-13] is pressed:
Recommendation: Charge the battery pack
*
before any further use.
7

Settings

CAUTION
Risk of injury
► Only adjust the settings when the power
tool is switched off.
7.1
Changing direction of rotation [1-9]
Switch to the left = clockwise rotation
Switch to the right = counterclockwise rota­
tion
7.2
Changing gear
You can change gear using the gear
switch [1-7].
16
70–100%
40–70%
15–40%
< 15%
*
7.3
Adjusting the torque [1-8]
Fastening
Select the correct torque setting:
Position 1 = low torque
Position 12 = high torque
An acoustic signal sounds when the preset tor­
que is reached and the machine then switches
off. You must release and press the ON/OFF
switch [1-4] again to start the machine.
Drilling
Mark is aligned with drill symbol
torque.
7.4
Impact drilling
The machine was designed for impact
drilling into tiles, masonry and stone.
Set the selector switch [1-6] to the hammer
symbol. Set the adjusting wheel [1-8] to the
drill symbol.
8

Tool holder, attachments

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
CAUTION
Risk of injury from hot and sharp tool
► Do not use any blunt or faulty tools.
► Wear protective gloves.
Prior to initial use: apply multi-purpose
grease to the drill spindle and gearbox
neck.
8.1
CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CEN­
TROTEC tool chucks.
Wear gloves when replacing!
8.2
Chuck [5]
For clamping drill bits and bits with max. shaft
di-ameter of 13 mm.
Clamp tool centrally in the chuck.
= maximum

Publicité

Table des Matières
loading

Table des Matières