transport rollers can be used to move it to its intended place of installation.
–
Please ensure proper disposal of all packaging materials.
●
Before it is connected to the mains, the unit must be thoroughly checked for transport damage,
including its power cord.
–
Clean the unit according to the instructions given in the
Installation
The appliance should be set up in a well-ventilated, dry room. It should be operated in an ambient
temperature of 16 to 32 °C and a relative humidity of max. 70 %. Do not expose the appliance to
direct sunlight, and do not position it next to any heat sources (radiators, cookers etc).
–
The rear and the sides should have a minimum clearance of 10 cm from the wall.
The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or
similar object.
Ensure that the door can swing open to an angle of 160°.
In the case of uneven floors, the adjustable feet on the unit can be used to compensate and ensure
optimum stability. The unit should be installed at a slight angle in such a way that it leans to the rear:
this will ensure that the door will close automatically and cannot be left open by mistake. Ensure,
however, that both front feet are set to the same height.
Ventilation
The heated air around the rear of the unit must be able to circulate freely. Therefore, ensure that the
air circulation behind the unit is not obstructed.
Reversible door
The design provides for the door to be reversed, i.e. for right-hinged (default installation) to become
left-hinged.
Before reversing the door, place the unit on its rear. However, ensure that it is resting on a soft ,
smooth surface to prevent damage to the capillary tubes.
Caution: Before reversing the door, switch off the unit and disconnect it from the mains.
1. Remove the screw covers.
De-frosting and cleaning section below.
16