How To Operate The Machine - Clarke FOCUS II AUTOSCRUBBER Disk 26 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

HOW TO OPERATE THE MACHINE

How To Operate the Squeegee
The squeegee wipes the floor while the vacuum motor
removes the dirty solution from the floor. Use your
hand to lower or raise the squeegee handle. To operate
the squeegee, follow this procedure:
1. To lower the squeegee rotate the squeegee lever
down. See figure 16.
2. To raise the squeegee, rotate the squeegee lever
up. See figure 16.
How to Fill The Solution Tank
1. Remove the solution tank lid. See figure 17.
2. If the machine does not have the Chemical
Mixing System, add a cleaning chemical to the
solution tank. For the correct amount of
chemical, follow the directions shown on the
container.
3. Fill the solution tank with water.
4. Replace solution tank lid.
WARNING:
Water solutions or cleaning
materials used with this type of
machine can leave wet areas on
the floor surface. These areas
can cause a dangerous condition
for the operator or other persons.
Always put CAUTION signs near
the area you are cleaning.
WARNING:
Machines can ignite flammable
materials and vapors. Do not use
with or near flammables such as
gasoline, grain dust, solvents,
and thinners. Only use a cleaning
concentration recommended by
the chemical manufacturer.
WARNING:
Clarke recommends a maximum
water temperature of 120°F(49°C)
®
Clarke
Operator's Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER
ENGLISH
Figure 16
Figure 17
®
EN
- 17 -

Publicité

Table des Matières
loading

Table des Matières