Calibrating The Position Sensors - Reely Redfox Notice D'emploi

13. Calibrating the position sensors

Before starting the helicopter, you should calibrate the position sensors. This ensures that the helicopter hovers
smoothly at one spot and does not fly in one direction spontaneously and without a control command.
Proceed as follows:
Power on the transmitter and the helicopter and place the
ready-to-start model on a level horizontal surface.
Then move both joysticks down to the left and hold them
in this position.
The transmitter emits a short beep and the helicopter LED
starts to flicker.
At this time, the swash plate moves to the left and back.
When the LED glows steadily, move the joysticks back to
the middle position. The calibration process of the position
sensors is now complete.
Figure 12
47