Troubleshooting - Reely Redfox Notice D'emploi

22. Troubleshooting

This model and the remote control were built using the latest technology. However, faults and malfunction may still
occur. The following section shows you how to troubleshoot potential problems.
Problem
The transmitter does not respond.
The transmitter LED flashes and the
transmitter beeps.
Helicopter battery charging time is very
short.
The rotors do not start.
The helicopter does not take off.
The helicopter does not respond to the
remote control.
The helicopter rotates about the verti-
cal axis (rotor shaft).
The flight time is too short
Model always drifts in one direction.
The model vibrates strongly in the air.
56
Solution
• Check the batteries in the transmitter (polarity) or replace them.
• Check the function switch.
• Replace the batteries in the transmitter.
• USB port amperage is too low.
• Replace the helicopter battery.
• Check the helicopter battery charge level.
• Check that the mechanical drive parts can move freely.
• Repeat the power on procedure.
• Check the flight battery charge level.
• Check that the mechanical drive parts can move freely.
• Check the rotor blades.
• Repeat the power on procedure.
• Avoid interference from other 2.4 GHz transmitters.
• Trim the model (see Figure 14).
• Repeat the power on procedure and ensure that you do not move or
rotate the helicopter.
• Check that the tail rotor runs smoothly and functions properly.
• Calibrate position sensors.
• Check the rotor blades.
• Recharge the helicopter battery (ensure that the USB port has suf-
ficient current).
• The helicopter battery is faulty.
• The mechanical parts cannot move freely.
• Calibrate position sensors.
• Trim the helicopter.
• Unfavourable flight conditions (draught).
• The rotors are defective.
• The motor shaft of the main or tail rotor is bent.
• Rotor blades are overtightened.
• The gear jams in places.