Setting Start Backtacking (B856E, B855E/Bt Only) - Brother E Série Manuel D'instructions

7. USING THE OPERATION PANEL
7. VERWENDUNG DER BEDIENUNGSTAFEL
7. UTILISATION DU PANNEAU DE COMMANDE
7. USO DEL TABLERO DE CONTROLES

7-6. Setting start backtacking (B856E, B855E/BT only)

After thread trimming (or after the treadle has been depressed backward for the B855E/BT), or at the sewing start
immediately after the SET key has been pressed to accept a setting, you can sew a set number of stitches at a narrow
pitch to create start backtack stitches.
The stitch pitch at this time can be adjusted using the condense dial. (If a negative value is set, the material will be fed
in the reverse direction.)
e
A
A UTO
TEST TEST
S E T
r
■ Turning the start backtack function on and off
Carry out the following settings after the thread has been trimmed (or after the treadle has been depressed backward
for the B855E/BT), or immediately after the SET key has been pressed to accept a setting.
The condition changes as shown below each time the start backtack key q is pressed.
•
Start backtacking is carried out when the start backtack indicator w is illuminated.
•
Zigzag width display, etc.
|
8 8 8 8
■ Start backtack sewing speed
The sewing machine operates at a speed of 1,200 rpm when sewing start backtack stitches.
93
Feed adjustment
dial
Condense dial
1 2 3 4 5 6 7 8 9
PA PAT T ERN ERN
S
S ROM
E
F
E
L
r
w
q
A
A
Illuminated
LZ2-B855E,B856E
Stitch pitch set
by condense dial
Stitch pith set
by feed adjustment
dial
• The number of start backtack stitches can be set with-
out having to press the SET key.
• Carry out the following settings after the thread has
been trimmed (or after the treadle has been depressed
backward for the B855E/BT), or immediately after the
SET key has been pressed to accept a setting.
1. Press the start backtack key q.
The indicator w will illuminate, and A** will appear
on the LED display e as the current setting for the num-
ber of start backtack stitches.
(For example,A+5 represents 5 start backtack
stitches.)
2. Press the △ and ▽selection keys r to change the set-
ting for the number of start backtack stitches to between
1 and 99.
3. Depress the treadle to start sewing the start backtack
stitches.
After this, stitches will be sewn at the pitch set by the
feed adjustment dial.
Note:
• The sewing machine will continue operating until the
set number of start backtack stitches has been sewn,
even if the treadle is returned to the neutral position.
• If the treadle is depressed backward, the needle will
stop in the needle up stop position at that point. (For
the B856E, the thread will be trimmed and then the
needle will stop in the needle up stop position.)
(If the zigzag stop position has been set, the needle
will stop in the set position.)
Number of start
backtack stitches
Zigzag width display
|
8 8 8 8
Off
A
＊ ＊
Number of
start backtack
stitches
8 8 8 8