Switching On And Off; Working With The Electric Hedge Trimmer - Grizzly EHS710-69 R Notice D'utilisation Originale

switch must not be held closed.
They must switch off the motor
when on is released. Should a
switch be damaged, stop working
with the equipment. Ensure that
the mains voltage value matches
the label on the equipment.
Note noise protection and local
specifications. The use of the
equipment on certain days (e.g.
Sundays and national holidays), at
certain times of day (lunch times,
night time quiet periods) or in spe-
cial areas (e.g. health resorts, clin-
ics etc.) is restricted or forbidden.
The blades continue to move for
a while after the equipment is
switched off. Allow the blades to
come to a complete standstill. Do
not touch the moving blades and
do not brake them. Risk of injury!

Switching On and Off

Ensure that you are standing in a
firm position with both hands grip-
ping the hedge trimmer away from
the body. Ensure that the trimmer
is in contact with no other objects
before switching on.
1. For tension relief of the cable,
form a loop of the end of the
extension cable and bring this
through the opening at the han-
dle and suspend in the tension
relief at the grip (8).
2. Connect the device to the mains
voltage.
3. To switch on, hold down the
safety switch on the bow handle
(4) and press the on/off switch
(7) on the handle at the same
time. The hedge trimmer runs at
top speed.
4. To switch off, release the on/off
switch. The braking effect can
cause the formation of sparks
in the area of the top ventilation
slits. This is normal and harm-
less to the equipment.
Working with the Electric
Hedge Trimmer
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage
to the cutter bar.
• Switch off the equipment immedi-
ately in the event that the blades are
blocked by solid objects, pull out the
power plug then remove the object.
• Always work away from the mains
power outlet. Set the cutting direction
before starting work. Ensure that the
power cable is kept well away from
the working area. Never lay the cable
over the hedge, where it could easily
be caught up in the trimmer blades.
• Avoid overstraining the equipment
during work.
Pull out the power plug imme-
diately if the cable is damaged,
badly twisted or has been com-
pletely cut through.
Adjusting the Grip:
The trimmer is equipped with an adjust-
able grip. The grip can be set to four posi-
tions in addition to the default position.
Simply select the position with which you
are most comfortable working. For exam-
UK
109