Trouble Shooting; Replacement Parts/Accessories - Grizzly EHS710-69 R Notice D'utilisation Originale

Trouble Shooting

Problem
Device does not start
Device runs with
interruptions
Blades become hot

Replacement parts/Accessories

Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre
(see "Grizzly Sercice-Center").
Possible cause
Mains voltage not on
On/Off switch (
defective
Worn carbon brushes
Defective motor
Power cable (
damaged
Internal loose electrical
connection
On/Off switch (
defective
Blades ( 2) are blunt
Blades ( 2) are notched
Too much friction due to
lack of lubrication
www.grizzly-service.eu
Fault correction
Check plug socket, cable, line
and plug, where appropriate,
have repaired through electrical
specialist
7)
Repair by Service Centre
Check the cable and have it
10) is
changed by the Service Centre if
necessary
Repair by Service Centre
7)
Have the blades sharpened or
replaced (Service Centre)
Have the blades checked or
replaced (Service Centre)
Oil the blades (
UK
2)
113