Attach The Shoulder Strap; Switching On And Off; Working With The Electric Hedge Trimmer; Swivelling The Arm - Grizzly EHS 900 L-Set Traduction De La Notice D'utilisation Originale

Attach the shoulder strap

Attach the shoulder strap spring clip
A
( 16) to the carrying eyelet (
the tubular shank of the device. Set the
strap length such that the spring clip on the
shoulder strap is roughly at the height of
your hip.

Switching On and Off

Ensure that you are standing in a
firm position with both hands grip-
ping the hedge trimmer away from
the body. Ensure that the trimmer
is in contact with no other objects
before switching on.
1. Form a loop in the end of the
extension cable and hook this
into strain relief on the end of the
equipment housing.
2. Connect the device to the mains
voltage.
3. To switch on, hold the safety
A
switch (
simultaneously press the on/
off switch (
trimmer will be run at maximum
speed.
4. The equipment will switch off
again when you release on/off
A
switch (
Working with the Electric
Hedge Trimmer
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage
to the cutter bar.
• Always hold the equipment firmly in
both hands, with one hand on the rear
handle and the other on the front han-
dle. Thumbs and fingers must be firmly
around the handles.
A
17) on
12) depressed and
A
13). The hedge
13).
• Switch off the equipment immedi-
ately in the event that the blades are
blocked by solid objects, pull out the
power plug then remove the object.
• Always work away from the mains
power outlet. Set the cutting direction
before starting work. Ensure that the
power cable is kept well away from the
working area. Never lay the cable over
the hedge, where it could easily be
caught up in the trimmer blades.
• Avoid overstraining the equipment dur-
ing work.
Pull out the power plug imme-
diately if the cable is damaged,
badly twisted or has been com-
pletely cut through.

Swivelling the Arm

Caution! The gear box (
becomes hot during operation.
There is a risk of burns. Do not
touch the gearbox housing or the
connection to the front arm (
E
1. Release the indexing by pushing
the safety slide (11) forward.
2. The tubular shank can now op-
tionally be turned 45° / 90° to the
right or the left (see the scale on
the device).
F

Lubricating the Gears

The angular gearbox requires lubrication
after approx. 20 operating hours.
To do this, use the lubrication port (3) to
press up to 5g standard grease into the
gearbox (2).
To do this, remove the locking screw on
the lubrication port (3) and grease the
gears. Then reclose the lubrication port
using the locking screw.
GB
A
2)
A
7).
125