Adjusting Strap Width - Titan PKE Notice D'instructions

8.3.

Adjusting strap width

The strap guide (m) located next to the feed wheel is replaced when the strap width is
modified. In order to do so the safety ring has to be removed by means of a
screwdriver and the air lever (c) and the compressed air motor (f) pressed together.
The strap guide may now be pulled off toward the front and be replaced with the strap
guide for other strap widths. Replace safety ring afterwards.
Strap width 13 mm order no. 2280001-500
Strap width 16 mm order no. 2280001-501
Strap width 19 mm order no. 2280001-502
Since the strap is guided at three points in the tool the back strap guide (n) and the
adjusting screw (o) also have to be set in such a way that the punching is placed at the
centre of the strapping strap.
In order to do this loosen the two fastening screws from the rear strap guide (n) (see
also figure 8.2) and adjust the desired strap width.
(Left → 13mm; Middle → 16mm; Right → 19mm).
Tighten lock nut and fasten screws after adjustment has been completed.
Loosen the countersunk head screw and the hex. nut at the strap guide front 302 and
place the appropriate number of washers DIN125-6.4 Pos. 78 under the strap guide:
(2 Discs → 13mm; 1 Disc → 16mm; without disc → 19mm).
Re-tighten the countersunk head screw and the hex. nut after adjustment.
Note!
Do not mount the strap guide front too firm. Keep it slightly
turning in order to reduce wear.
Strap width
13 mm
16 mm
19 mm
PKE
Discs (Pos.78)
2 Stück
1 Stück
0 Stück
o
H228 EU 12/15
m n
32 / 59