Residual Risks - Güde ISG 1200-1 Traduction Du Mode D'emploi D'origine

minimal power fluctuations means it can also be used
to operate electrically controlled consumers.
When connected to a stationary device such
as heating, electrical power, air conditioning
equipment or for the supply of mobile homes, it
is necessary to contact a professional electrician
and heating manufacturer as far as connection
and grounding is concerned.
Not observing general regulations in force and
instructions from this manual does not make the
manufacturer liable for damages.
Protective equipment „Protective separation with
potential balancing" is provided and integrated by
the producer.
Please note that our equipment has not been
designed for commercial, craft or industrial use. If the
equipment is used in commercial, craft or industrial
operation or for similar activities, we cannot assume
any liability.
The machine may only be used in a technically
perfect condition and taking into account all safety
information.
Connection, installation and
operation
Caution: Before using the product it is essential
to check whether the appliance is suitable to be
operated with the unit. Specifications of the ap-
pliance must always match the details and safety
instructions of the unit.
Do not connect the appliance before the unit is run-
ning at full speed. Disconnect the appliance before
turning the unit off.
Never connect another appliance when there is
one being operated. This would inevitably lead to
fluctuations able to destroy electronically controlled
equipment.
The electric energy consumption is the critical point
of an induction appliance ehen starting. Electric
energy consumption can be 3-5 times higher than the
rated power that must necessarily be considered.

Residual risks

Even when the device is used properly and all safety
regulations are complied with, there still may be
some residual risks.
Risk of fire!
Never operate the unit near highly flammable
materials.
Fuel is highly flammable.
Keep the fuel in suitable containers only.
The appliance may only be refuelled outdoors and
not near open fire or burning cigarettes.
Refuel before starting the appliance. If the engine is
running or still hot, it must not be refuelled or the
tank cover opened.
After use, let the unit cool down for at least 10
minutes before refuelling.
Make sure the fuel does not overflow. If the fuel
overflows, the engine must not be started. Remove
any dirt from the appliance and prevent any at-
tempt at ignition until fuel fumes have evaporated..
Replace all fuel tank and container caps securely.
Fuel tank to be emptied outdoors only.
Risk of poisoning!
Exhaust gases, fuel and lubricants are toxic. Inhaling
exhaust gases may be fatal!
Do not operate the unit in closed spaces where dan-
gerours carbon monoxide gases may accumulate.
Danger of burns !
Some parts of the appliance get too hot when the
appliance is operated. Do not touch any hot parts,
e.g. engine and muffler.
Contacting hot parts of the unit may cause burns.
Do not touch any hot parts, e.g. engine and muffler.
Let the unit cool down after its operation is over.
Risk of explosion!!
Petrol and petrol vapours are highly flammable,
explosive.
Do not work with the unit in an environment with a
risk of explosion where there are flammable liquids,
gases or dust.
Refuel the engine only when switched off.
Do not store any fuel near the unit.
Never keep the unit with petrol in the tank inside a
building where petrol vapours could get in contact
with open fire or sparks.
Risk of electric shock.
Direct electrical contact may cause electric shock.
Never touch the unit with wet hands.
Provide adequate grounding.
ENGLISH
25