Replacement Of Cutter (47); Cleaning Work Zone - Titan TA 250 Notice D'instructions

10.4. Replacement of cutter (47)

To replace the cutter (47) please proceed as
follows:
Loosen the screw (100) and remove the
protective cover (99).
Loosen the screw (49) and remove the
cutter guide (48).
Remove the cutter (47) and replace it
against a new one.
Reassemble all in reverse order.

10.5. Cleaning work zone

Remove the plastic strap residues from feed wheel, gripper plates, welding plate and cutter,
exclusively by means of compressed air, at regular intervals, depending on use.
TA 250 / TA 450
(0001) H TA 250 / 450 EU 38/15
99 100
47
48
49
60 / 112