Charger - Titan TA 250 Notice D'instructions

9.2. Charger

To operate the charger put the socket-averted side
of the power cable in the charger and the connector
in a socket which is fed with power of 110 V / 230 V.
Explanation of charging stages:
Green LED is
bright
Green LED
flashes
Red LED is bright
Red LED flashes
2 short beeps
1 long beep
2 short beeps
every one minute
after full charge
reached
fast intermittent
continuous beeps
After the end of the charging operation remove the Li-Po storage battery from the charger
and also pull the mains connector of the charger out of the socket. This helps avoid
unnecessary expenses for power.
TA 250 / TA 450
(0001)
Visual signals
Storage battery fully charged
charge 100 %
Storage battery is being charged
charge 80 to 99 %
Storage battery is being charged
charge 0 to 80 %
Storage battery overheated or
voltage below 10.4 V.
(troubleshooting required see item
11)
Sound signals
Storage battery OK
charging cycle starts
Storage battery full loaded
Storage battery full loaded but still
housed into charger
Storage battery has trouble –
charge didn't allow
H TA 250 / 450 EU 38/15
55 / 112