Manual Strapping - Titan TA 250 Notice D'instructions

7.1. Manual strapping

For tensioning the strap press push-button 1
and keep it pressed, until the strap tension
desired is achieved.
After releasing push-button 1 it can still be
actuated maximum 3 times to increase strap
tension.
To form a seal push push-button 2. Friction
welding starts.
The LED is bright and an audible acoustic signal
indicates the end of the welding cycle after a few
seconds. The strap is cut automatically.
The seal is formed!
Pull the lever 3 toward the grip and hold it.
Now the strap is released. Turn the strapping
tool to the right side away from the strapping
while holding the lever.
TA 250 / TA 450
(0001) H TA 250 / 450 EU 09/15 45 / 112