Hilti DX A40 Mode D'emploi page 10

After cleaning, assemble the tool in reverse order. Set power regulation to min. (1). When
putting the exhaust gas piston return unit into the housing, the mark on the piston return unit
(screw) must align with the mark on the housing. When the two guide pins of the piston return
unit are properly positioned, the piston return unit can be screwed in without any great effort.
1
–
+
1
2
Cartridges
Ordering designation Colour code
6.8/11 M green green
6.8/11 M yellow yellow
10
10
Printed: 07.07.2013 | Doc-Nr: PUB / 5069863 / 000 / 00
2
1
Power level
light
medium
4
2
11
3
13
9
6
7
5
1
12
8
Warranty
Hilti warrants that the tool supplied is free of defects in material and workmanship. This war-
ranty is valid so long as the tool is operated and handled correctly, cleaned and serviced prop-
erly and in accordance with the Hilti Operating Instructions, all warranty claims are made
within 5 years for the tool and 1 year for the marking head from the date of the sale (invoice
date), and the technical system is maintained. This means that only original Hilti consumables,
components and spare parts, or other products of equivalent quality, may be used in the tool.
This warranty provides the free-of-charge repair or replacement of defective parts only. Parts
requiring repair or replacement as a result of normal wear and tear are not covered by this
warranty.
Additional claims are excluded, unless stringent national rules prohibit such exclusion.
In particular, Hilti is not obligated for direct, indirect, incidental or consequential dam-
ages, losses or expenses in connection with, or by reason of, the use of, or inability to
use the tool for any purpose. Implied warranties of merchantability or fitness for a par-
ticular purpose are specifically excluded.
For repair or replacement, send tool and/or related parts immediately upon discovery of the
defect to the address of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to warranty and supersedes all prior or
contemporaneous comments and oral or written agreements concerning warranties.
Quantity Ordering designation
1 Marking head DX A-CM
1 Impact extractor assembly
* Impact extractor (1×), O-ring 34×3 (1×), absorber CM (1×)
1 O-ring 34×3
1 Absorber CM
1 Detent HM assembly
* Detent HM (1×), compression spring 0.4×5.0×10.9 (1×), annular spring NM (1×)
1 Compression spring 0.4×5.0×10.9
1 Annular spring NM
1 Axle A 40-CM
1 Piston-retainer-kit 5.566
* Annular spring (1×), * ball 5.566 (2×)
1 Label warning
1 Hex Skt Scr M 6×30
1 Breech
1 Piston X-AP15 H
* Impact extractor, detent HM, annular spring and ball 5.566 are not individually available.
Item no.
268057/7
268056/9
268164/1
268158/3
268017/1
4892/6
267979/3
268054/8
268205/2
23579/6
72477/3
23586/1
267900/9