MRA 4025066156993 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windshield
4 Rubber nuts M5
4 Oval-head screws M5x16mm
4 Plastic washers
4 Socket head screws M6x12mm
4 Washers
1 Retaining plates, pair
How to install the windshield on your motorcycle
1. Position the motorcycle on a level surface.
2. We recommend that you cover the mudguard with a soft cloth just to be safe.
3. Use the 5mm hex key to remove the two retaining screws of the headlight holder
(P 1).
4. Turn the headlight holder slightly upward.
5. Now install the included retaining plate from inside using the M6x12mm socket head
screws and the 6mm washers on the holes provided in the headlight holder (P 2).
6. Adjust the position of the retaining plate and tighten the screws. Please note that one
retaining plate each is included for the right and left sides (P 3).
7. Then reinstall the headlight holder on the motorcycle. Repeat all steps on the other
side.
8. ATTENTION: Do not remove both headlight holders at the same time, as this will
cause the headlight to drop onto the mudguard.
9. Now push the M5 rubber nuts into the retaining plates and install the MRA windshield
on the retaining plates using the M5x16mm oval-head screws and the plastic washers.
10.Adjust the position of the windshield and tighten the screws.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
YAMAHA XSR 900
Article No..
--- 3mm und 5mm hex key
10629
10554
10635
10866
11050
11168
3
Required tools