Changing The Base Runner; Aluminium Processing; Accessories - Festool OF 2200 EB Notice D'utilisation D'origine

Procedure
Lay the machine on its side on a stable base.
Open the lever [14.4].
Remove the base runner [14.1].
Release the lever [14.4] again.
Insert a copying ring [14.3] in the correct posi-
tion on the router base.
Insert the tabs [14.2] on a base runner into the
router base.
Push down the base runner until it engages in
the router base.
The overhang Y of the workpiece in relation the
template [Fig. 15] is calculated as follows:
Y = ½ (diameter of copying ring minus diameter of
routing bit)
c) Edge trimming
Routing tools with a bearing guide are required
when the machine is used for edge trimming. The
machine is then guided in such a way that the
bearing guide rolls off the workpiece.
When trimming edges, always use the chip defl ec-
tor KSF-OF to improve dust extraction.
d) Routing with a guide system FS
The guide system (partly as an accessory) makes
it easier to route straight grooves.
Secure the guide rail to the workpiece using
clamps [16.4].
Insert the base runner [16.3] for the guide stop
into the router base (see "Changing the base
runner").

This base runner is offset to compensate for
the height of the guide rail.
Secure both guide rods [16.6] with the rotary
knobs [16.5] and [16.9] on the guide stop.
Unscrew the rotary knob [16.1].
Insert the guide rods [16.6] into the grooves on
the router base.
Place the router with the guide stop on the
guide rail.
If required, you can adjust the play of the guide
stop on the guide rail by adjusting the two guid-
ance jaws [16.2] with a screwdriver.
Slide the router along the guide rods until the
routing tool reaches the required distance X
from the guide rail.
Screw up the rotary knob [16.1].
Unscrew the rotary knob [16.10].
18
Turn the adjusting wheel [16.7] to adjust dis-
tance X more precisely.

Hold the adjusting wheel [16.7] to turn the
scale [16.8] independently to "zero".
Screw up the rotary knob [16.10].

8.2 Changing the base runner

Festool offers special base runners (as an acces-
sory) for different applications.
Change the base runner as follows:
Lay the machine on its side on a stable base.
Open the lever [14.4].
Remove the base runner [14.1].
Release the lever [14.4] again.
Insert the tabs [14.2] on a base runner into the
router base.
Push down the base runner until it engages in
the router base.
Before using the base runner: remove the protec-
tive foil!

8.3 Aluminium processing

WARNING
Risk of accident - always perform the following
safety measures when routing aluminium:
Add a residual-current circuit-breaker (FI,
PRCD).
Connect the machine to a suitable dust ex-
tractor.
Remove dust deposits from the motor hous-
ing on a regular basis.
Wear protective goggles.
9

Accessories

For your own safety, use only original Festool ac-
cessories and spare parts.
The accessory and tool order number can be
found in the Festool catalogue or on the Internet
under „www.festool.com".