Changing The Base Runner - Festool OF 2200 EB Guide D'utilisation

14
– Open the lever [17.4].
– Remove the base runner [17.1].
– Release the lever [17.4] again.
– Insert a copying ring [17.3] in the correct
position on the router base.
– Insert the tabs [17.2] on a base runner into
the router base.
– Push down the base runner until it engages
in the router base.
The overhang Y of the workpiece in relation
the template is calculated as follows:
Y = ½ (diameter of copying ring minus
diameter of routing bit)
c) Edge trimming
Routing tools with a bearing guide are required
when the machine is used for edge trimming.
The machine is then guided in such a way that
the bearing guide rolls off the workpiece.
When trimming edges, always use the chip
defl ector KSF-OF to improve dust extrac-
tion.
d) Routing with a guide system FS
The guide system (partly as an accessory)
makes it easier to route straight grooves.
19.1
19.2
19.3
– Secure the guide rail to the workpiece using
clamps [19.4].
– Insert the base runner [19.3] for the guide
stop into the router base (see "Changing
the base runner").
This base runner is offset to compensate
for the height of the guide rail.
– Secure both guide rods [19.6] with the
rotary knobs [19.5] and [19.9] on the
guide stop.
– Unscrew the rotary knob [19.1].
– Insert the guide rods [19.6] into the
grooves on the router base.
– Place the router with the guide stop on the
guide rail.
– If required, you can adjust the play of the
guide stop on the guide rail by adjusting
the two guidance jaws [19.2] with a
screwdriver.
– Slide the router along the guide rods until
the routing tool reaches the required
distance X from the guide rail.
– Screw up the rotary knob [19.1].
– Unscrew the rotary knob [19.10].
– Turn the adjusting wheel [19.7] to adjust
distance X more precisely.
Hold the adjusting wheel [19.7] to turn the
scale [19.8] independently to "zero".
– Screw up the rotary knob [19.10].

Changing the base runner

Festool offers special base runners (as an
accessory) for different applications.
Change the base runner as follows:
20.1
19.10
19.9
19.8
20.2
19.7
19.6
19.5
20.3
– Lay the machine on its side on a stable
19.4
base.
– Open the lever [20.3].
– Remove the base runner [20.1].
– Release the lever [20.3] again.
– Insert the tabs [20.2] on a base runner into
the router base.
– Push down the base runner until it engages
in the router base.