Intended Use; Technical Data; Parts Of The Device - Festool OF 1400 EQ Notice D'utilisation D'origine

English
– Do not clamp tools with an unsuitable
shank diameter in the clamping collet.
– Only use tools that meet standard
EN 847-1. All Festool routing tools fulfill
these requirements.
– Ensure that the router bit is seated firmly
and that it runs perfectly.
– The clamping collet and locking nut must
not show any signs of damage
– Do not use cracked or deformed router
bits.
–
Wear suitable personal protective equip­
ment: Ear protection, protective goggles,
dust mask for work that generates dust,
protective gloves for working with rough
materials and for changing tools.
– Only for AS/NZS: The tool shall always be
supplied via residual current device with a
rated residual current of 30 mA or less.
2.3 Sawing aluminium
When sawing aluminium, the following meas­
ures must be taken for safety reasons:
– Install an upstream residual-current circuit
breaker (RCD, PRCD).
– Connect the power tool to a suitable dust
extractor with an antistatic suction hose.
– Regularly clean dust deposits from the mo­
tor housing on the power tool.
– Wear protective goggles.
2.4 Emission levels
The levels determined in accordance
with EN 62841 are typically:
Sound pressure level
Sound power level
Uncertainty
CAUTION
Noise generated when working
Risk of damage to hearing
► Use ear protection.
Vibration emission level a
three directions) and uncertainty K measured in
accordance with EN 62841:
16
L = 95 dB(A)
PA
L = 106 dB(A)
WA
K = 3 dB
(vector sum for
h
a <2.5 m/s
h
K = 1.5 m/s
The specified emission levels (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise
load during operation.
– They represent the primary applications of
the power tool.
The emission values may deviate from the
specified values. This is dependent on how
the tool is used and the type of workpiece
being machined.
► The actual load during the entire operating
cycle must be evaluated.
► Depending on the actual load, suitable pro­
tective measures must be defined in order
to protect the operator.
3

Intended use

The router is designed for routing wood, plas­
tics and wood-based materials.
If the cutters are used for the intended purpose
outlined in the Festool Sales, they may also be
used to machine aluminium and plasterboard.
This power tool may only be used by experts or
instructed persons.
The user is liable for improper or non-in­
tended use.
4

Technical data

Router
Power consumption
Speed
Max. speed (no-load)
Quick depth adjustment
Fine depth adjustment
Drive shaft connecting
thread
cutter diameter
Weight as per EPTA pro­
cedure 01:2014:
5

Parts of the device

[1-1] Depth stop scale
2
[1-2] Indicator screw
2
CAUTION
OF 1400 EBQ
OF 1400 EQ
10,000–22,500 rpm
23,000 rpm
M22 x 1.0
Max. 63 mm
1400 W
70 mm
8 mm
4.4 kg