Routing With The Fs Guide System; Changing The Base Runner; Service And Maintenance; Accessories - Festool OF 2200 EB Notice D'utilisation

English
8.5

Routing with the FS guide system

The guide system (available as an accessory
depending on the model) makes it easier to
route straight grooves.
► Secure the guide rail to the workpiece using
fastening clamps [16-4].
► Insert the base runner [16-3] for the guide
rail adapter into the router table of the rout­
er (see section 8.6). This base runner has a
ridge which adjusts to the height of the
guide rail.
► Clamp the two guide rods [16-6] on the
guide rail adapter using the rotary
knobs [16-5] and [16-9].
► Open the rotary knob [16-1].
► Insert the guide rods [16-6] into the
grooves of the router table.
► Place the router with the guide rail adapter
on the guide rail.
► If necessary, use a screwdriver on the two
guidance jaws [16-2] to adjust the play be­
tween the guide rail adapter and the guide
rail.
► Move the router along the guide rods until
there is the required distance between the
cutter and the guide rail. Ensure that there
is a safety distance X of (see figure [16])
5 mm between the front edge of the guide
rail and the cutter, or the groove.
► Close the rotary knob [16-1].
► Open the rotary knob [16-10].
► Precisely adjust distance X by turning the
adjusting wheel [16-7]. Hold the adjusting
wheel [16-7] to separately turn the
scale [16-8] and set it to zero.
► Close the rotary knob [16-10].
8.6

Changing the base runner

Festool offers special base runners (available
as an accessory) for different applications.
► Lay the power tool on its side on a stable
base.
► Release the lever [14-4].
► Remove the base runner [14-1].
► Release the lever [14-4] again.
► Insert the base runner with the tabs [14-2]
into the router table.
► Push the base runner into the router table
until it engages.
When using the base runner for the first
time: Remove the protective film.
22
9

Service and maintenance

WARNING
Risk of injury, electric shock
► Always pull the mains plug from the socket
before performing any servicing and main­
tenance work.
► All maintenance and repair work which re­
quires the housing to be opened should al­
ways be carried out by an authorised serv­
ice workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.co.uk/service
5
3
2
1
The tool is equipped with special self-discon­
necting carbon brushes. If they wear out, the
power supply is disconnected automatically and
the tool stops.
Observe the following instructions:
► If it is necessary to replace the mains power
cable of the power tool, this must be re­
placed by the manufacturer or an author­
ised service workshop, so as to avoid safety
hazards.
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating instructions.
► To ensure constant air circulation, always
keep the cooling air openings in the housing
clean and free of blockages.

10 Accessories

Always use original Festool tools and accesso­
ries. Using low-quality tools or accessories
from other manufacturers may increase the
risk of injury and seriously unbalance the ma­
chine, decreasing the quality of the working re­
sults and accelerating power tool wear.
Refer to the Festool catalogue for the order
numbers of accessories and tools or find them
online at www.festool.co.uk.