Emission Levels; Commissioning; Adjustments - Festool OF 2200 EB Notice D'utilisation D'origine

the body leaves it unstable and may lead to loss
of control.
- Ensure that the router bit is seated fi rmly and
that it runs perfectly.
- The clamping collet and locking nut must not
show any signs of damage.
- Only use tools that meet standard EN 847-1. All
Festool routing tools fulfi l these requirements.
- The maximum rotational speed specifi ed on the
tool must not be exceeded and the rotational
speed range must be observed.
- Do not use cracked or deformed router bits.
- Do not clamp tools with an unsuitable shank di-
ameter in the clamping collet.
- Wear suitable protection such as ear protection,
safety goggles, a dust mask for work which gen-
erates dust, and protective gloves when working
with raw materials and when changing tools.
- Festool electric power tools should only be in-
stalled in work benches specially designed by
Festool. The electric power tool may become
unsafe and cause serious accident if installed
in benches from other manufacturers or self-
manufactured work benches.

5.3 Emission levels

Noise levels are measured in accordance with EN
60745:
Sound pressure level
Noise level
Uncertainty
CAUTION
The noise produced during work can damage
your hearing.
Always use ear protection.
Overall vibration levels (vector sum for three direc-
tions) measured in accordance with EN 60745:
Vibration emission level
(3-axis)
Uncertainty
The specifi ed emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise loads
during operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with
other insertion tools or if not maintained adequat-
ely. Take note of idling and downtimes of machine!
14
6
Risk of accident if the machine is operated us-
ing unauthorised voltages or frequencies.
The mains voltage and the frequency of the
In North America, only Festool machines with
The switch [2.2] is an on/off switch. Press the side
locking knob [2.1] to lock the switch for continu-
ous operation. Press the switch again to release
the knob.
7
Risk of accident, electric shock
Always pull the plug out of the socket before
7.1 Electronics
The OF 2200 EB features full-wave electronics
L = 87 dB(A)
with the following properties:
PA
L = 98 dB(A)
Smooth start-up
WA
K = 3 dB
The electronically controlled smooth start-up
function ensures that the machine starts up
smoothly.
Speed control
You can regulate the rotational speed steplessly
between 10000 and 22000 rpm using the adjust-
ing wheel [1.11]. This enables you to optimise the
cutting speed to suit the respective material and
routing tool:
2
a < 2,5 m/s
h
K = 1,5 m/s²
Material
Hardwood
Softwood

Commissioning

WARNING
power source must correspond with the spec-
ifi cations on the machine's name plate.
the voltage specifi cations 120 V/60 Hz may be
used.

Adjustments

WARNING
performing any type of work on the machine.
Routing tool diameter
10 -30 30 - 50 50 - 89
Adjusting wheel setting
6 - 4
6 - 5
[mm]
HW
5 - 3 3 - 1
(HSS)
HSS
6 - 4 5 - 3
(HW)