Changing The Base Runner; Aluminium Processing; Accessories, Tools - Festool OF 2200 EB Guide D'utilisation

– If required, you can adjust the play of the guide
stop on the guide rail by adjusting the two guid-
ance jaws [19.2] with a screwdriver.
– Slide the router along the guide rods until the
routing tool reaches the required distance X from
the guide rail.
– Screw up the rotary knob [19.1].
– Unscrew the rotary knob [19.10].
– Turn the adjusting wheel [19.7] to adjust distance
X more precisely.
 Hold the adjusting wheel [19.7] to turn the scale
[19.8] independently to "zero".
– Screw up the rotary knob [19.10].

Changing the base runner

Festool offers special base runners (as an acces-
sory) for different applications.
Change the base runner as follows:
20.1
20.2
20.3
– Lay the machine on its side on a stable base.
– Open the lever [20.3].
– Remove the base runner [20.1].
– Release the lever [20.3] again.
– Insert the tabs [20.2] on a base runner into the
router base.
– Push down the base runner until it engages in
the router base.

Aluminium processing

The following precautions are to
be taken when processing aluminium for safety
reasons:
• Pre-connect a residual current circuit-breaker.
• Connect the machine to a suitable dust extrac-
tor.
• Clean tool regularly of dust accumulations in the
motor housing.
Wear protective goggles.

Accessories, tools

For safety reasons, only use origi-
nal Festool accessories and tools!
Festool offers you a comprehensive range of acces-
sories for your router:
• Routing tools for different applications.
• Guide rails for straight routing.
• Runner bases for different applications.
The accessory and tool order number can be found
in the Festool catalogue or on the Internet under
www.festoolusa.com.
Systainer
Many Festool products are shipped in a unique
system container, called "Systainer". This provides
protection and storage for the tool and accessories.
The Systainers are stackable and can be interlocked
together. They also can be interlocked atop Festool
CT dust extractors.
– To open the Systainer:
• Turn the T-loc [21.1] to the position
– To lock the Systainer:
• Turn the T-loc [21.1] to the position
– To connect two Systainers:
• Place one Systainer on the top of the other
(Fig. 21 A).
• Turn the T-loc [21.1] to the position
(Fig. 21 B).
The Systainers are connected and locked.
 A new generation Systainer is connectable on
top of a previous generation Systainer by the four
latches of the previous Systainer.
15
.
.
or