Commissioning; Switching On/Off; Settings; Changing Tools - Festool MFK 700 EQ Notice D'utilisation

The specified illustrations appear at the begin­
ning of the Operating Instructions.
6

Commissioning

WARNING
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
CAUTION
Heating of the Plug it connection if bayonet
fitting is not completely locked
Risk of burns
► Before switching on the power tool, make
sure that the bayonet fitting at the mains
cable is closed fully and locked.
Connecting and detaching the mains power ca­
ble - see Fig. 2.
6.1

Switching on/off

The switch [1-9] serves as an on/off switch (I =
ON, 0 = OFF).
7

Settings

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
7.1 Electronics
Constant speed
The preselected motor speed is kept constant
through electronic control. This ensures a uni­
form speed even when under load.
Speed control
You can use the adjusting wheel [1-8] to contin­
uously adjust the speed within the speed range
(see Section Technical data). This enables you
to optimise the speed to suit the respective ma­
terial. Please also note the specifications on the
tools.
Scorch or melt marks on the material can be
prevented through reducing the speed.
Temperature cut-out
The power supply is restricted and the speed
reduced if the motor exceeds a certain temper­
ature. The power tool continues operating at re­
duced power to allow the ventilator to cool the
motor quickly. The power tool starts up again
automatically once the motor has cooled suffi­
ciently.
Restart protection
The built-in restart protection prevents the
power tool from starting up again automatically
if the power is disconnected when the on/off
switch is pressed. In this case, the power tool
must be switched off and then switched back on
again.
Due to the built-in restart protection, the power
tool cannot be switched on and off via an exter­
nal switch module.
7.2 Replacing router table
The router table for edging is optimally de­
signed for cutting protruding edging thanks to
the large contact surface.
► Slide router table onto mounting bolts of
machine [3].
► If nec., remove ball bearing brake [3-2].
► Secure locking for router table [3-1].
► If nec., insert ball bearing brake [3-2].
Removal in reverse order.
7.3

Changing tools

CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
Before replacing the cutter remove the router
table.
Removing the tool
► Push spindle lock [4-1].
► Slacken union nut [4-2] using open ended
spanner (SW 19) until the tool can be re­
moved.
► Release spindle lock [4-1].
Inserting the tool
► Position the cutter [4-3] as far as possible,
at least as far as the marking
cutter shaft, into the open clamping collet.
► Push spindle lock [4-1].
English
at the
15