SOLIS 586 Mode D'emploi page 52

13. If you want to reheat the water to the set temperature, you can simply touch
the ON/OFF button again resp. change the temperature setting.
Caution: The appliance will only switch on and heat the water if the difference
between current water temperature and set water temperature is at least 5°C.
14. If you do not need any more hot water, pull the power plug, pour the remain-
ing water out of the kettle and let the appliance cool down.
Tips:
To save energy, the appliance can not be immediately reactivated after heating
•
water to 100°C. The water in the kettle has to have cooled down to about 90°C
before you can restart the boiling process.
Do not tilt the filled kettle too much and never turn it upside down, even when
•
the lid is firmly shut. Water can escape even when the lid is closed!
Always make sure that the lid is locked to the kettle before switching on the
•
appliance.
To lower the pressure in the kettle, it is recommended to keep the button for
•
unlocking the spout latch pressed for a few seconds after the boiling process
before lifting and emptying the kettle.
O V E R H E AT P R O T E C T I O N
■
Should the appliance overheat, f.e. if there is no or too little water in the kettle
•
or if it has already evaporated, the appliance automatically switches off. In this
case, pull the plug and let the appliance cool down for approx. 15 minutes before
using it again.
52