Yamaha PLG150-AP Mode D'emploi page 18

Parameters
Treble Gain
Range: -64 – +00 – +63
This determines the level of the selected frequency (in "Treble Freq" above). Positive values boost the level of the
selected frequency and negative values attenuate it.
REV Send (Reverb Send)
Range: -127 – +127 ("****": not available)
This determines the amount of voice signal that is sent to the PLG150-AP's built-in Reverb effect.
CHO Send (Chorus Send)
Range: -127 – +127 ("****": not available)
This determines the amount of voice signal that is sent to the PLG150-AP's built-in Chorus effect.
INS LFOFrq (Insertion LFO Frequency)
Range: -127 – +127 ("****": not available)
This determines the frequency of LFO modulation for the PLG150-AP's built-in Insertion effect.
INS LFODpt (Insertion LFO Depth)
Range: -127 – +127 ("****": not available)
This determines the depth of LFO modulation for the PLG150-AP's built-in Insertion effect.
INS Feedback (Insertion Feedback Level)
Range: -64 – +63 ("***": not available)
This determines the feedback level for the PLG150-AP's built-in Insertion effect.
INS DryWet (Insertion Dry/Wet Balance)
Range: -127 – +127 ("****": not available)
This determines the balance between the direct, unprocessed signal (dry) and the Insertion-processed sound
(wet).
INS Offset (Insertion Offset)
Range: -127 – +127 ("****": not available)
This parameter is used to change one specific parameter of the effect; the particular parameter depends on the
effect type.
INS Drive (Insertion Drive)
Range: -127 – +127 ("****": not available)
This determines the amount of distortion overdrive for the PLG150-AP's built-in Insertion effect.
INS ClpCrv (Insertion Clipping Curve)
Range: -127 – +127 ("****": not available)
This determines the amount of distortion "edge" for the PLG150-AP's built-in Insertion effect. Higher values result
in harder edged distortion.
INS Delay (Insertion Delay Time)
Range: -7149 – +7149 ("*****": not available)
This determines the delay time for the PLG150-AP's built-in Insertion effect.
18
PLG150-AP Owner's Manual
• Keep in mind that these parameters are offset controls; the actual resulting effect sound will differ
NOTE
from voice to voice. If the currently selected voice does not have any effect or uses an effect type
not corresponding to this parameter, the parameter is unavailable and is indicated by asterisks
("***") in the display.
• Whether this Insertion effect parameter is available or not depends on the selected voice and its pre-
assigned Insertion effect types. (For details on the effect types and parameters for each voice, see
the Preset Voice Bank on page 20.)