Parameters; Ap Native Part Parameters - Yamaha PLG150-AP Mode D'emploi

Parameters

AP Native Part Parameters

Keep in mind that the parameter values and settings represent offsets of the actual voice settings. This
means that the actual sound that results from the settings made here depends on the original settings
of the voice.
Also keep in mind that these are "Part" parameters and as such, are temporary; they simply alter or
offset the settings of the currently selected voice. The original voice settings are permanently main-
tained in memory.
For parameter values, a setting of "0" results in no change, while positive and negative values increase
and decrease the value respectively.
Let's look at a specific example. If the original Bass Frequency parameter of the selected voice is set
to 100, and you set the Bass Frequency (below) to "-25," the actual Bass Frequency will become "75."
If you set it to "+10," the value will become "110." Naturally, this also means that the parameter
value cannot be increased or decreased beyond its maximum or minimum values. In our example,
Bass Frequency values higher than "+27" have no effect on the sound, since the actual range is 0 –
127.
• Depending on the selected voice and the particular parameter being edited, the sound or actual parameter
NOTE
value of certain voices may change very little or not at all, even when the parameter value is changed drasti-
cally.
• For Modular Synthesis Plug-in System compatible devices, the voices you edit/create can be stored to the
device as PLG voices. For details on storing voices, refer to the owner's manual of your Modular Synthesis
Plug-in System compatible instrument.
PF Mode
Settings: ON, OFF
This determines whether the PF (Piano) Mode is on or off. When this is set to "ON" and damper (sustain) pedal
messages are received, the PLG150-AP simulates the sound of a damper pedal.
If monophonic playback has been selected on your synthesizer, this parameter cannot be set.
SusCurve (Sustain Curve)
Settings: Normal, Step ("***": not available)
This determines how the voices respond to damper (sustain) pedal messages. When this is set to "Normal," the
PLG150-AP simulates the actual damper pedal action of an acoustic piano, giving you continuous control over sus-
tain. When this is set to "Step," sustain is simply turned on or off in response to damper pedal messages.
If "PF Mode" (above) has been set to OFF or monophonic playback has been selected on your synthesizer, this
parameter cannot be set.
Bass Freq (Bass Frequency)
Range: -64 – +00 – +63
This determines the frequency which is boosted or cut (in the Bass Gain parameter below) for each Part.
Bass Gain
Range: -64 – +00 – +63
This determines the level of the selected frequency (in "Bass Freq" above). Positive values boost the level of the
selected frequency and negative values attenuate it.
Treble Freq (Treble Frequency)
Range: -64 – +00 – +63
This determines the frequency which is boosted or cut (in the Treble Gain parameter below) for each Part.
(PLG150-AP NATIVE MULTI PART (page 29))
PLG150-AP Owner's Manual
17