Operating Dos 6.22 And Setup - Siemens SIMATIC VS710 Notice D'utilisation

SIMATIC VS710
4.3

Operating DOS 6.22 and SETUP

The following steps will take you to the VS710 operator level you require:
Switch off VS710
Establish RS232 cable
connection between the
host PC and VS710
Connect VGA monitor to
VS710
Insert Tool Diskette 1 in
the diskette drive of the
host PC
Start HOSTKEY or
REMOTE.BAT from drive A:
Switch on VS710
Go to MS-DOS
To boot up the
VS710-internal drive C:
Remote control of VS710
from host PC
To end remote control of
the VS710:
CTRL-ALT-F10: reboot
CTRL-X: exit
Figure 17 Using HOSTKEY to Operate the VS710
Note
-
To avoid taking up too much memory, only a minimal subset of DOS 6.22 is
loaded on the VS710. Other DOS utilities are available on Tool Diskette 1.
- You cannot copy files from VS710 back onto a diskette while emulation is in
progress. To do so, try starting INTERSVR.EXE from a suitable
AUTOEXEC.BAT (startup file).
- Time and date settings are lost if the VS710 is de-energized; for example, if the
power supply fails or if you pull the plug. Backups are not made.
24
Quick Reference Guide
Go to SETUP
Press F2 to start SETUP
Perform SETUP functions
To reboot the VS710:
Press Ctrl-Alt-F10
SIMATIC VS710
C79000-K8576-C167-01