ProCharger 4.000 Mode D'emploi page 33

- Option A - Charging the battery with the charging clamp cable while
installed: Connect the charging clamp cable to the charger using the quick
connector (if you have not already done so). Then, first connect the red
charging clamp (plus) to the positive terminal on the battery. After doing so,
connect the black clamp (minus) to the vehicle chassis or the engine block,
but not in the vicinity of the battery, the fuel supply line or the carburettor,
and not to metal clips or moving parts. The negative terminal of the charger
is connected to the vehicle chassis or to the engine block in accordance
with the EN standard, i.e. a little distance away from the battery. This
prevents explosive gases which may be in the direct vicinity of the battery,
from igniting due to sparks on the battery terminal.
- Option B - Charging the battery with the charging clamp cable while
removed: Connect the charging clamp cable to the charger using the quick
connector (if you have not already done so). Then, first connect the red
charging clamp (plus) to the positive terminal on the battery. Then, connect
the black clamp (minus) to the negative terminal on the battery.
- Option C - Charging with the ring terminal cable:
First disconnect the motorcycle earth connection from the battery. Then,
screw the red ring connector (plus) of the ring terminal cable on the
battery's positive terminal. Then, screw the black ring connector (minus) of
the ring terminal cable on the battery's negative terminal. Then, re-connect
the motorcycle's earth connection to the minus terminal on the battery.
Then, connect the ring connector cable to the charger using the quick
connector.
- Option D - Charging using the vehicle socket and the optional ProCharger
charger plug:
Connect the charger plug cable to the charger using the quick connector (if
you have not already done so). Insert the charger plug into the socket on
your motorcycle.
• Now connect the battery charger to the mains power. The „
• Now, using the MODE button, select the respective charging mode within 5
seconds. If the button is not pressed, the charging process will start with the
charging mode that was last selected. In order to change the charging mode
again, disconnect the charger from the mains power and then connect the
charger again to the mains power. Use the MODE button within 5 seconds to
select the charging mode.
• The charging process then starts automatically and is signalled by the charge
capacity LEDs „ , , , "
" LED lights up.
33