Fuse; Specifications - ProCharger 4.000 Mode D'emploi

14. Fuse

If the charging process does not start, the 10 A fuse in the charging cable may be
faulty. In this case, replace the fuse and check the cabling.

15. Specifications

Operating voltage................................................... 220 - 240 V/AC (50/60 Hz)
End-of-charge voltage............................................ 14.3 V/14.7 V
Charging current ................................................... max. 1000 mA /
Housing protection class........................................ IP 65
Operating conditions.............................................. -15°C to +45°C, 10% to 90%
Storage conditions................................................. -30°C to +60°C, 10% to 90%
Dimensions (W x H x D).......................................... 212 x 78 x 57 mm
Weight.................................................................... approx. 690 g
Length of power cord............................................. approx. 170 cm
Length of charging cable (total)............................. approx. 230 cm
Fuse protection for charging cable........................ 10 A
Usable battery types.............................................. Lead-acid, lead-gel, lead-fleece
Battery voltage....................................................... 12 V
Battery capacity (recommended)........................... 1.2 Ah to 60 Ah
max. 4000 mA
(depending on charging mode)
air humidity, non-condensing
relative air humidity,
non-condensing
(AGM), calcium, pure lead,
LiPo and Li-ion vehicle batteries
37