Quick Connector; Ring Terminal Cable - ProCharger 4.000 Mode D'emploi

12. Quick connector

You can use the ProCharger quick connector to connect charger clamp cables, ring
connector cables and other compatible ProCharger accessories to the ProCharger
charger. To do so, both parts of the quick connector are joined together so that they
engage in place. The plug-in connector on the quick connector is reverse polarity
protected and can only be connected in one position. To disconnect this connection,
you have to actuate the red rocker on the adapter and unfasten the plug-in connector
by gently pulling it apart. In the process, never pull or push on the cable; always take
hold of the housing of the plug-in connector.

13. Ring terminal cable

The ring terminal cable is designed for permanent connection to the vehicle battery.
First disconnect the motorcycle earth connection from the battery. Then screw the
red ring terminal (plus) of the ring terminal cable on the battery's positive terminal.
Then, screw the black ring terminal (minus) of the ring terminal cable on the battery's
negative terminal. Then, re-connect the motorcycle's earth connection to the negative
terminal on the battery. In the process, proceed with care. It is imperative that you
prevent short circuits and make sure the contact is secure. The ring terminal cable
has to be attached to the vehicle so that it cannot be trapped, does not rest directly
on the hot motor and is kept away from all moving parts. Since this is a universal
product, you must make sure that the ring terminal cable can be used properly and
without problems with your type of vehicle before using it for the first time. In the
process, it is imperative that you adhere to the specifications and guidelines of the
vehicle and battery manufacturer.
36